Air Machinegun Forum

i had gotten two years back from OPP, the ones for the MP661K model, it goes into maghead n comes down thru mag ,out bottom of mag, then you screw a quick disconect on it,,,basically one end is threaded for maghead, the other to accept the quick disconect to a bulk line ,,,but i think i printed out all the demensions for them and could post it up if someone wants to make them

jus for shits n giggles, what would you guys value my drozd bumblebee at/ 18v, ported mt valve, gettin a hpa tank w/a regulator set to 1200 or 1400psi output, have jc's 1st prototype smg barrel, rifled & hardened  18 inch, not the 16 like the kits, it has pistolpacker's board 1200rof, n his straight thru to mag mag bulk adapter (have spares of each of those new ) 2 xtra mags, one is new, still wrapped, 2 20 oz co2 tanks, that tank/buttstock bulk adapter setup, a regular hosed adapter, stock barrel, mock supressor which makes it louder haha, custom wooden carbine stock , quick release swivel disconnects & sling,,,nothin special for sights,a cheap red rot laser, gonna upgrade to reflex halographic sight hi enough up that regular sights can still be used,,,i think i got it back in early 2006 new original box, loader, manual  and a bag full xtra parts and printed info on how to modify them off the russian sites translated,,remember back then? haa    anyhow,,,probably will have 800+ into it easily....never chronied, 700+pages telephone book w/co2... it will eat up a 12 gram cartridge in one mag with an unmodded mag head or valve..viddies after i hook it all up n blast some stuff